b'Note: Serviceability Limit State (SLS) wind 2.3.2 COMMERCIAL WIND TABLE - AS/NZS 1170.2 WIND LOADS pressures are limited to +1 kPa, -1.5 kPa for V2.2.1/FV1.1 WeatherproofingExtend fastenerDesign Wind Frame length when packingFastening Pattern Fastener PressureMaximum Stud distance exceeds the(Ultimate) kPa Spacingfollowing1 600Paslode ND50 SS2.5 450Traditional Product Code:B20054A & B20665(Brad & Fuel pack) 4 4007 300MGP10 TimberDirect Fix Traditional / Semi- 1 600MinimumConcealed2.5 450Traditional 45mm x 2.5mm Ring Shank Nail4 4007 300Semi-Concealed6.5 300Buildex Treated Pine 10g1 600MGP10 Timber9.5mm Traditional 8x50mm Countersunk Rib2.5 450MinimumHead Screw. Product Code: X503298 3.5 300Traditional/ Semi- 1 600Concealed 2.5 4500.55mm/G550 SteelSCROOZ 8g x 42mm FibreFix Minimum thickness 20mm Traditional Cement Board Screw4 400Product Code: FFSC0842T7 300Semi-Concealed 6.5 3001 600Iccons SD CSK COARSE C32.5 4500.75mm/G550 Steel12mm Traditional 10-16 X 40mm Screw Minimum Thickness Product Code:4 400SDCSC1040C36 3001 6000.75mm/G550 SteelIccons SD CSK Wing Cs 10-162 450Minimum Thickness 20mm Traditional x 45mm Screw Product Code: TP723 2.5 4003.5 300Fastener & Wind Table Requirements and RecommendationsWind classification results have been conducted allowing for maximum packing distances specified in the tables. The fastener length must be increased to accommodate for the thickness of larger battens and/or additional packing materials to ensure the same penetration into the structural subframe.The above tables are relevant for on & off stud joining methods for timber and steel frames.The spans of the weatherboard shall be continuous spans of 2 spans or greater. Simply supported spans are not permitted.Span/150 serviceability limit state deflection criteria. All fasteners must be galvanised or suitably coated to resist corrosion for external application (Australian Standard AS 3566, Class 3 for screws). When installed in high corrosion zones such as coastal locations, fasteners (nails and screws) must be made of materials appropriate to the desired life of the system and geographical location. Stainless Steel Nails and Class 4 Screws may be necessary in these zones. The advice of the fastener supplier should be sought.ND Bradnails are not suitable for use with Semi-concealed fixing of Selflok products.Bradnails are not recommended for use on Smooth profiles as they may create an undesirable surface finish. Bradnails are an excellent choice for use with Woodsman and Ruff-Sawn profiles.Screws used underneath the lip for Semi-Concealed fastening must be flush and not countersunk.For Natural range use stainless steel fasteners only.Weathertex 23'